Yamaha FZS6V(C) Owner's Manual page 53

1. Maximum level mark
2. Minimum level mark
3. Coolant reservoir
3. If the coolant is at or below the
minimum level mark, remove the
seat. (See page 3-10.)
4. Remove the fuel tank bolts, and
then lift the fuel tank away from the
coolant reservoir cap. (See page
6-15.)
5. Open the coolant reservoir cap.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Coolant reservoir cap
6. Add coolant or distilled water to
raise the coolant to the specified
level, close the coolant reservoir
cap, and then place the fuel tank in
the original position and install the
bolts.
7. Install the seat.
Coolant reservoir capacity (up to the
maximum level mark):
0.27 L (0.29 US qt) (0.24 Imp.qt)
CAUTION:
G If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
6-14
G
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
G
If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
NOTE:
G
The radiator fan is automatically
switched on or off according to the
coolant temperature in the radia-
ECA10470
tor.
G
If the engine overheats, see page
6-39 for further instructions.
EWA10380
6