Handlebar Switches - Yamaha YZFR3AN 2021 Owner's Manual

Handlebar switches

Left
1
2
4
1. Pass switch "PASS"
2. Dimmer switch " / "
3. Horn switch " "
4. Turn signal switch " / "
Right
1
2
1. Start/Engine stop switch "
2. Hazard switch " "
EAU1234R
Pass switch "PASS"
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch "
Set this switch to "
3
beam and to "
TIP
When the switch is set to low beam,
both headlights for low beam come on.
When the switch is set to high beam,
both headlights for high beam come
on.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
/ / "
turned to the center position.
Instrument and control functions
EAU12362
EAU85410
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
4-10
Horn switch " "
Press this switch to sound the horn.
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to " ", and then slide
the switch toward " ". See page 6-2
for starting instructions prior to starting
the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard lights switch " /OFF"
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
EAU12501
EAU68271
/ "
4
EAUN2210