Yamaha FZS6V(C) Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
G
two tachometers, one LCD and
one digital (which show engine
r/min)
G an odometer (which shows the to-
tal distance traveled)
G
two tripmeters (which show the
distance traveled since they were
last set to zero)
3
G
a fuel reserve tripmeter (which
shows the distance traveled since
the bottom segment of the fuel
meter started flashing)
G
a clock
G
an air intake temperature display
G
a fuel meter
G a coolant temperature meter
G a self-diagnosis device
NOTE:
G
Be sure to turn the key to "ON" be-
fore using the "SELECT" and "RE-
SET" buttons.
G To switch the speedometer and
odometer/tripmeter displays be-
tween kilometers and miles, press
the "SELECT" button for at least
two seconds.
Odometer, tripmeter and digital ta-
chometer modes
Pushing the "SELECT" button switches
the display between the odometer
mode "ODO" and the tripmeter modes
"TRIP 1" and "TRIP 2" ("TRIP F") and
the tachometer "E" in the following or-
der:
ODO → TRIP 1 → TRIP 2 → (TRIP F)
→ E → ODO
When the fuel amount in the fuel tank
decreases to 3.6 L (0.95 US gal) (0.79
Imp.gal), the bottom segment of the
fuel meter will start flashing, and the
odometer display will automatically
change to the fuel reserve tripmeter
mode "TRIP F" and start counting the
distance traveled from that point. In that
case, pushing the "SELECT" button
switches the display between the vari-
ous tripmeter and odometer modes in
the following order:
TRIP F → E → ODO → TRIP 1 → TRIP
2 → TRIP F
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
3-4
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
Clock
To switch the air intake temperature
display to the clock, first set the display
to the odometer or tachometer mode,
and then push the "RESET" button for
at least two seconds.
NOTE:
The clock is automatically displayed
when the key is turned to "OFF".
To set the clock:
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.