KVH Industries TracVision G6 Technical Manual page 106

The antenna unit's printed circuit boards (PCBs), gyro, azimuth
limit switch, LNB, elevation motor, and elevation drive belt may
be removed and replaced on site using common hand tools.
Other TracVision G6 service must be done by your authorized
dealer/installer, distributor or by KVH. Evidence of tampering or
unauthorized repairs will void the warranty. The following
sections provide step-by-step procedures for removing and
replacing field replaceable units.
Figure 5-1 depicts the location of a number of components within
the TracVision G6 antenna unit.
European
Dual-output
LNB
Elevation Motor
and Drive Assembly
PCB Cover
and PCBs
Azimuth Limit
Switch Assembly
54-0161
European
Quad-output
LNB
Tie-wraps
TracVision G6 components
receive power from multiple
sources. Do not open any
electrical assemblies or attempt
servicing until IRD power and
vessel input power are
disconnected.
Figure 5-1
TracVision G6 Antenna Unit
(Baseplate Cut Away)
North American/
Latin American LNB
Antenna Gyro
Azimuth Motor
Maintenance
107