Using The Spool Stand - Baby Lock Destiny BLDY Instruction And Reference Manual

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
■ Position "3"
The multi-purpose screwdriver can be positioned
over the screw on the embroidery frame to tighten
the screw after hooping the fabric or when removing
the fabric.
Note
• When rotating the multi-purpose
screwdriver, do not forcefully rotate it in the
direction that it does not rotate; otherwise, it
may break.

Using the Spool Stand

The included spool stand is useful when using
thread spools with a large diameter (cross-wound
thread). The spool stand can hold two spools of
thread.
1 2
4 5
7 8
No. Part Name
1 Telescopic thread guide
2 Spool support
3 Spool pin × 2
4 Screw and washer
5 Spool cap (XL) × 2
6 Spool holder × 2
7 Spool cap base × 2
8 Spool felt × 2
9 Ring × 4
24
■ How to assemble the spool stand
a
b
3
6
9
Part Code
XE0776-001
XE4958-101
XA6313-051
XC7568-051
XE0779-001
XA0679-050
XE0780-001
XC7134-051
026030-136
CAUTION
• Do not lift the handle of the machine while the
spool stand is installed.
• Do not push or pull the telescopic thread
guide or spool pins with extreme force,
otherwise damage may result.
• Do not place any object other than spools of
thread on the spool support.
• Do not try to wind thread on the bobbin while
sewing using the spool stand.
Fully extend the telescopic thread guide
shaft, and then rotate the shaft until the two
internal stoppers click into place.
Insert the telescopic thread guide into the
round hole at the center of the spool
support, and then use a screwdriver to
securely tighten the screw (a) from the
reverse side.
a Screw