Using The Dual Feed Foot; Attaching The Dual Feed Foot - Baby Lock Destiny BLDY Instruction And Reference Manual

CHANGING THE PRESSER FOOT
f
Set the operation lever of the walking foot
so that the needle clamp screw is set in the
fork. Position the shank of the walking foot
on the presser foot bar.
a Operation lever
b Needle clamp screw
c Fork
d Walking foot shank
e Presser foot bar
g
Lower the presser foot lever. Insert the
screw, and tighten the screw securely with
the screwdriver.
CAUTION
• Use the included screwdriver to tighten the
screw securely. If the screw is loose, the
needle may strike the presser foot and cause
injury.
• Be sure to rotate the handwheel toward you
(counterclockwise) to check that the needle
does not strike the presser foot. If the needle
strikes the presser foot, injury may result.
70

Using the Dual Feed Foot

Dual feed foot enables you to have best fabric
control when sewing difficult fabrics that slip
easily, such as quilted fabrics or fabrics that tend
to stick to the bottom of a presser foot, such as
vinyl, leather or synthetic leather.
Note
• When sewing with the dual feed foot, sew at
medium to low speeds.
Memo
• When selecting stitches to be used with the
dual feed foot, only the stitches that can be
used will be activated on the display.
• When sewing fabric that easily sticks
together, a more attractive finish can be
achieved by basting the beginning of
sewing.

■ Attaching the Dual Feed Foot

a
Follow the steps in "Removing the Presser
Foot" on page 68.
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
a Multi- purpose screwdriver
b Presser foot holder screw
c Presser foot holder
c
Position the dual feed foot to the presser
foot bar by aligning the notch of the dual
feed foot to the large screw.
Side view