Download Print this page

Before First Use - Goldair GSDM200 Operating Instructions Manual

Slushie maker

Advertisement

Before first use

Remove all packing materials and manual
from inside your Slushie maker.
DO NOT immerse the motor base in water
or other liquids. Hand wash all the paddles
and the Slushie container), making sure
that the spigot is open when washing to
allow water to flow through.
Assembly
NOTE: Do not plug the power cord into an
electrical outlet until the unit is fully
assembled.
1.
Place base on dry, level surface.
2.
Place the Slushie container on the
motor base. Ensure that the container
is sitting correctly on the drive shaft,
with the spigot directly over the drink
tray.
3.
Insert the ice canister into the Slushie
paddles, then insert the ice paddles
into the ice canister
Cleaning
DO NOT wash any part of the appliance in
the dishwasher. Hand wash only.
DO NOT immerse the motor base in water.
The exterior surface of the motor base can
be wiped clean with a damp cloth.
1.
Remove the Slushie container from
the motor base and remove the lid.
Parts should be washed with warm water
and a mild dish washing detergent and
wiped completely dry. '
DO NOT use abrasive cleaners to clean
as these may damage your appliance.
The drive shaft may be wiped clean with a
damp (Not wet) cloth.
4.
5.
6.
2.
Remove the ice canister assembly
from the slushie container.
3.
Discard the brine (ice water & salt)
from the ice canister.
4.
Carefully lift locking latches from the
ice paddles and disassemble the ice
canister assembly.
5.
Fill canister with warm soapy water
and open the spigot to allow clean
water to run through.
6.
Use a small flexible bottle brush to
clean the inside of the spigot.
SUPPORT AND TECHNICAL ADVICE
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz
The locking latches on the ice
paddles should easily snap onto the
Slushie paddles.
Place the canister assembly into the
Slushie container, ensuring that the
ice canister sits flush onto the drive
shaft at the base of the Slushie
container.
Place lid on Slushie container. Put the
front end on first, then secure the
locking latch onto the rear locking
notch of the canister
Monday – Friday 8am-5pm
Phone +61 (0)3 9336 4423
info@cdbgoldair.com.au
Goldair – Australia
Phone 1300 465 324

Advertisement

loading