HP ProLiant SL2x170z G6 Server Maintenance And Service Manual page 45

To install the riser card:
Tighten two screws which secure the riser card to the PCIe bracket. Put the bracket down.
Figure 26 Installing the riser card
To install the PCIe bracket:
Align the PCIe bracket slot to the connector on the main board and then push the card into the
1.
connector.
Install and tighten the screw that secures the PCIe bracket to the chassis.
2.
Figure 27 Installing the PCIe bracke
To remove the PCIe card:
Remove the screw that secures the PCIe card.
1.
Open the PCIe latch.
2.
Pull the PCIe card back and away from the PCIe riser card.
3.
Slide the PCIe bracket across the chassis.
4.
Close the PCIe latch.
5.
t
Removal and replacement procedures 45