HP A7173A Installation Manual page 18

HP-UX Installation: HP A7173A PCI-X Dual Channel Ultra320 SCSI Host Bus Adapter
Verifying the Installation
# mptconfig /dev/mpt8
Scan For Devices ...
---- ADAPTER INFORMATION -----------------------------------------------------
Device File
Hardware Path
---- BUS PARAMETERS ----------------------------------------------------------
Initiator SCSI ID
SCSI Bus Rate
SCSI Bus Width
---- CHANNEL CAPABILITIES ----------------------------------------------------
Req/Ack Offset
Bus Mode
Quick Arbitration Selection
DT Clocking
Packetized
---- TARGET PARAMETERS -------------------------------------------------------
Target Description
Id
------------------------------------------------------------------------------
0 ST318453LC
2 ST373453LC
4 ST373453LC
------------------------------------------------------------------------------
#
NOTE When the system boots after installation, the insf command creates the proper device files for
the "ctl" interfaces (which would include the A7173A adapter) as well as the SCSI devices
attached to the A7173A adapter. Sometimes, however, the insf command does not create all of
the device files that are needed. For example, this happens when you attach SCSI disks to the
adapter after the system boots, but the adapter is already installed in the system.
If you see a SCSI device listed in the ioscan output, but there is no device file in the second
line of the ioscsan output for that device, the device file is missing. To solve this problem, issue
the insf -e command, which will create all of the device files.
For more information about the ioscan command, see the ioscan(1M) man page.
For more information about the insf command, see the insf (1M) man page.
Refer to your system documentation for information about verifying system operation.
18
: /dev/mpt8
: 1/0/4/0/0
: 5
: Ultra320
: Wide
: 127
: LVD
: Enabled
: Enabled
: Enabled
Firmware In Use In Use
Version Rate Width
HPC3 Ultra320 Wide
HPC3 Ultra320 Wide
HPC4 Ultra320 Wide
Chapter 2