Table of Contents
Advertisement
Step 1. Access the system adapter bay
•
If the system is running, shut it down.
•
Wait for the system to shut down completely, and then power off the system.
•
Open the system to gain access to the PCI backplane.
•
For better performance, insert the adapter into the highest performance PCI slot available.
Step 2. Install the adapter
•
Slide the adapter edge-connector into the PCI slot until it is fully seated.
•
Secure the adapter and reassemble the system.
Figure 3-1The HP A7173A PCI-X Dual Channel Ultra320 SCSI Host Bus Adapter
NOTE
Chapter 3
Linux Installation: HP A7173A PCI-X Dual Channel Ultra320 SCSI Host Bus Adapter
Do not use the internal connector and the external connector on the same channel
simultaneously.
A7173A Adapter Linux Quick Installation
23
Advertisement
Table of Contents
