Chrysler Plymouth 1962 Owner's Manual page 32

THE SAFE WAY TO CHANGE A WHEEL
1. Shut engine off and set parking brake. Car should be parked on as flat a surface
as possible. Block both sides of wheel diagonally opposite to the one to be re-
moved.
2. Remove spare wheel, jack and base and lug wrench from luggage compartment.
See page 26 for Station Wagon jack storage.
3. Pry off hub cap with flat end of lug wrench.
4. Loosen nuts (bolts)
before using jack.
Turn
left
on right
wheels (passenger side
of car) and right on left
wheels.
S. Place lilting hook on
jack, using top hole
for front bumper and
bottom hole for rear
bumper.
6.
F it jack hook in slot
provided on bottom
edge of bumper and
set jack in position
without slanting.
7. Insert lug wrench in jack; set
control finger for "Up" positi.on
and
I'pump"
until wheel is clear
of ground.
8.
Remove nuts (bolts) and pull
wheel off Hub.
9.
Install spare and lightly tighten
nuts (bolts), alternating from
upper left to lower right and
upper right to lower left. Set
control finger for "Down" posi-
tion and lower car. Then finish
tightening. Put hub cap in place
and hit sharply with heel of hand.
Remove blocks from wheel.