Hotpoint HUI614 K Instructions For Installation And Use Manual page 24

Care and Cleaning
GB
Glass Inner Door with three Panels
now be washed at the sink. Stubborn stains can be
removed by using a fine steel wool soap pad. Ensure the
glass panel is not subjected to any sharp mechanical
blows. Take particular care not to damage the inner
surface which is coated with a heat reflective layer. After
cleaning, rinse and dry with a soft cloth. For slight soiling
the inner glass panel may be cleaned, while still warm,
without removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down
doors, except take care to support the weight of the
inner glass when removing and refitting.
Take care during cleaning not to damage or distort the
door seals. Do not lift the door seal from the oven chassis,
if necessary remove the seal by carefully unhooking the
corner clips.
Take care that the rating label edges are not lifted during
cleaning, and furthermore that the lettering is not blurred
or removed.
When refitting the glass make sure it is fitted correctly i.e.
reflective face is fitted the right way round.
Anti- rattle bung
WARNING : Be careful not to lose the bungs when
cleaning
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
24
Open the door fully
and carefully slide the
inner glass towards you,
taking care not to allow
the glass to fall.
The glass panel may
The door glass is equipped
with anti-rattle bungs
which prevents rattling of
the glass when opening
and shutting the oven
main door. These can be
removed for washing.
Cleaning the glass doors
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down
doors.
now be washed at the sink. Stubborn stains can be
removed by using a fine steel wool soap pad.
Replace in the reverse order.
Ensure anti-rattle bungs are fitted before fitting inner
door glass.
BE CAREFUL NOT TO DAMAGE THE GLASS PANELS
BY PUSHING THEM TOO HARD.
When fitting the glass make sure it is fitted correctly ie
reflective face is fitted the right way round.
Ensure the glass panel is not subjected to any sharp
mechanical blows. Take particular care not to damage
the inner surface which is coated with a heat reflective
layer. After cleaning, rinse and dry with a soft cloth. For
slight soiling the inner glass panel may be cleaned, while
still warm, without removing it from the door
Warning: Oven must not be operated with inner door
glass removed.
Open the lower door
and lift out the inner
door glass
Remove the two rubber
anti-rattle bungs
Remove the centre glass
taking care to support
the weight of the glass
when removing and
fitting
The glass panels may