Setting The Unit At Work; Setting The Operating Set Point - Zanotti DFZ Use And Maintenance Instructions

4.2 Setting the unit at work

Press push-button 1 to turn on the driver's cabin control. The mask shown in
f i g . 2 will appear after a few seconds.
This mask shows:
• TA1: Cold room temperature
• SP1: operating set point
• current date and time,
• type of diesel operation, either slow (LOW) or fast (HIGH).
CAUTION
Only use push-button 1 to turn off (or on) the electronic control unit if the refrig-
eration unit is not used. Always use the
and off ( f i g . 2 ).

4.3 Setting the operating set point

Press key . The mask below will be displayed.
Press key . The cursor will start blinking under the present SP1 set point
value.
Press the UP/DOWN key to change such value.
Press key to store the defined value.
60
button only to turn the refrigerator on
f i g . 2
f i g . 3