Kenwood KVT-920DVD Instruction Manual page 59

Installing the Antenna Units
• Attach the antenna to the inner glass surface of the rear window using double-sided tape. Carefully check the installation
location as the tape can only be stuck on once.
• If the surface temperature of the glass of the rear window is low, warm it by turning on the power of the rear defogger.
A cold window glass surface will weaken the adhesive strength of the double-sided tape.
Also, if installation inside the cabin is performed on a day with high humidity or when it is raining, the high humidity level will
weaken the adhesive strength of the double-sided tape.
• Do not install the antenna in a location where it may obstruct the field of view during driving, such as on the windshield.
1
Check the location where the antenna is to be attached.Clean off
any grease or dirt from the installation location using the supplied
glass cleaner
(Accessory P)
to dry.
2 CAUTION
Clean the glass thoroughly as failure to clean the glass can not
only weaken the adhesive strength of the double-sided tape, but
may also cause it to come loose.
2
Remove the protective strips from the antenna parts and the
back of the antenna unit.
3
Attach the double-sided tape of the antenna parts and the
antenna unit to the rear windshield glass. Attach the double-
sided tape by firmly pressing down from the top. Secure cables
using the supplied clampers.
4
After attaching the antenna with the double-sided tape, allow it
to sit undisturbed for 24 hours. Take care not to apply force to
the antenna or allow it to get wet during this time.
5
Cable the antenna cable to receiver unit.
Booster switch
, clean the area with water and allow
• Set this booster switch to "OFF" if there is ghosting of the
on-screen image due to electromagnetic fields.
• Please set the booster switch to the "ON" position in case of
a weaken field area.
Antenna parts
Antenna unit
Bundle cables with the
clamper bar
(Accessory Q)
Rear window
Rear seat
59