Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kenwood KVT-729DVD
Summary of Contents for Kenwood KVT-729DVD
-
Page 1: Installation Manual
MONITOR WITH DVD RECEIVER KVT-729DVD INSTALLATION MANUAL © B54-4516-00/00 (EV) - Page 2 Accessories KVT-729DVD ...1 ...1 ...1 ...1 ...1 ...2 ...4 ...4 ...2 ...1 ...2...
-
Page 3: Installation Procedure
Therefore, the speaker wire should be checked. • If your car is not prepared for this special connection- system, consult your Kenwood dealer. • Only use antenna conversion adapters (ISO-JASO) when the antenna cord has an ISO plug. - Page 4 PRK SW Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle.
- Page 5 Receiver unit Accessory 3 Receiver unit FM/AM antenna input ILLUMI REVERSE REMO.CONT MUTE ANT CONT P. CONT EXT. CONT Accessory ! The cable (Accessory 3) is fixed with a chassis using harness band (Accessory Wiring harness (Accessory 1) Ground wire (Black) - (To car chassis) If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire.
-
Page 6: Connecting Wires To Terminals
Gray Gray/Black White White/Black Green Green/Black KVT-729DVD 2WARNING Functions Connecting the ISO Connector The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit. -
Page 7: System Connection
System Connection Receiver unit ■ Front Preout • Audio left output (White) • Audio right output (Red) ■ Rear Preout • Audio left output (White) • Audio right output (Red) ■ Subwoofer Preout • Audio left output (White) • Audio right output (Red) ■... -
Page 8: Optional Accessory Connection
Receiver unit Connection cable (Included in the Disc changer) Disc Changer etc. (Optional Accessory) TV Tuner (Optional Accessory) UNIT MONITOR KVT-729DVD Audio Input Resistance-free stereo type mini plug (3.5Ф) Visual Input Resistance-free mini plug (3.5Ф) USB terminal INPUT ANTENNA Connection cable... -
Page 9: Installation For Monitor/Player Unit
Installation for Monitor/Player Unit Screw (M4X8) (commercially available) Self-tapping screw (commercially available) Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Installation for Receiver Unit 1. Attach the installation brackets 9 to the sides of the receiver unit using the sems bolts 7. -
Page 10: Removing The Unit
• The frame can be removed from the top side in the same manner. 2. When the lower level is removed, remove the upper two locations. KVT-729DVD Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>.