Controls And Status Lamps; Control Panel - IVT Optima 1000 Assembly, Commissioning And Maintenance Manual

Control panel

Control panel
The control panel is the heart of your heat pump installation. All
settings are made from the control panel and it also displays any
alarms. When you have made your settings, the control panel makes
sure they are saved in the control unit Rego 603 to carry out your
wishes.

Controls and status lamps

Alarm status
Lamp fl ashes: A fault has occurred in the heat pump.
Lamp lit: The alarm has been acknowledged and the heat
pump waits for the cause of the fault to reset.
Hot water status
Lamp lit: The heat pump is heating water in the hot water
heater.
Lamp fl ashes: The heat pump has a hot water peak or is
producing extra hot water.
Additional heat status
Lamp lit: The heat pump is using additional heat from, e.g.
an electric cassette.
Operating status
Lamp lit: The heat pump (compressor) is operational.
Lamp fl ashes: The heat pump will start within 15 minutes.
Lamp not lit: The heat pump (compressor) is not opera-
tional.
Power switch (ON/OFF)
You start and stop the heat pump using the power switch
button.
Lamp on: The heat pump is on.
Lamp fl ashes: The heat pump is off.
Heat
Temperature
Pressing once gives a shortcut to the most frequent
temperature settings.
Info
Info
Pressing once gives continuous information about the heat
pump's and additional heat's operating conditions.
Menu
Menu
Press once to enter the main menu. The main menu
contains all setting menus and temperature displays.
Menu display
Menu buttons
Menu dial
Status lamps
Power switch
(ON/OFF)
12
Rego 603 K1
040216 16:08:15 Tu
Heat Info Menu
Menu display
Rego 603 K1
040216 16:08:15 Tu
Heat Info Menu