Kenwood SJM100 series User Manual

b c d
G
G
safety
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
This appliance is not intended for
G
use by persons (including children)
Measure 1 cup to boil faster and
with reduced physical, sensory or
save energy.
mental capabilities, or lack of
experience and knowledge, unless
before using your Kenwood
they have been given supervision or
appliance
instruction concerning use of the
Read these instructions carefully
appliance by a person responsible
and retain for future reference.
for their safety.
Remove all packaging and any
Children should be supervised to
G
labels.
ensure that they do not play with
the appliance.
Only use the appliance for its intended
G
Always use the filter and never domestic use. Kenwood will not
accept any liability if the appliance is
overfill - boiling water may splash
subject to improper use, or failure to
out.
comply with these instructions.
Avoid contact with steam coming
out of the spout area when pouring
before plugging in
and out of the lid or spout area
G Make sure your electricity supply is
when refilling.
the same as the one shown on the
Beware: the metal body of the
underside of your kettle.
kettle will get hot during operation.
Important - UK only
Never let the cord hang down
The wires in the cord are coloured
G
where a child could grab it.
as follows:
Always unplug your kettle
Green and Yellow = Earth
when not in use.
Blue = Neutral
Never put the kettle, powerbase,
Brown = Live.
cord or plug in liquid.
The appliance must be protected
G
Never use a damaged appliance.
by a 13A approved (BS1362) fuse.
Get it checked or repaired: see
G WARNING: THIS APPLIANCE
'service and customer care'.
MUST BE EARTHED.
Caution: Do not operate the kettle
on an inclined surface.
Note:
Only use the powerbase supplied
For non-rewireable plugs the fuse
G
and keep it clean and dry.
cover MUST be refitted when
Make sure the lid is secure before
replacing the fuse. If the fuse cover
switching the kettle on.
is lost then the plug must not be
Warning: Do not open the lid
used until a replacement can be
while the water is boiling.
obtained. The correct fuse cover is
Take care when opening the lid -
identified by colour and a
droplets of hot water may be
replacement may be obtained from
ejected.
your Kenwood Authorised Repairer
Make sure the kettle is switched off
(see Service).
before lifting or pouring.
G If a non-rewireable plug is cut off it
Remove the kettle from the base
must be DESTROYED
before filling or pouring.
IMMEDIATELY. An electric shock
Never put the kettle near or on
hazard may arise if an unwanted
cooker hot plates or gas burners.
non-rewireable plug is inadvertently
This kettle is for boiling water only.
inserted into a 13A socket outlet.
This appliance conforms to EC 2 Check the lid is closed. Close the
G
directive 2004/108/EC on lid by pushing down on the finger
Electromagnetic Compatibility and pad area
EC regulation no. 1935/2004 of 3 Plug in and switch on.
27/10/2004 on materials intended 4 Your kettle will boil and switch off
for contact with food. automatically. To re-boil, wait a few
seconds - the on/off switch needs
before using for the first time
time to reset.
1 Wrap any excess cord around the
G If you experience problems
bracket on the underside of the
with your kettle switching on
powerbase .
and off during use or
2 Clip the into place if using
switching off before boiling,
: see "using the kettle with the
check that the flat element is
".
free from scale - see
G Your kettle can be safely used
"descaling".
without the , just lift out
Your kettle is fitted with a filter to
G
using the central divider and use
hold back limescale particles.
the kettle as normal.
If you find drops of water under
G
3 Fill to 'MAX', boil, then pour the
your kettle, don't worry - it is just
water away. Repeat 2 to 3 times.
condensation.
key
boil-dry protection
G If you switch on with too little water,
spout
your kettle will cut out automatically.
finger pad
Switch off, remove from the
flip top lid
powerbase and let it cool down
lid release button
before re-filling. When it has cooled
water level windows
down, the switch will reset itself.
on/off switch with indicator light
360° powerbase
using the kettle with the
cord wrap
filter
1 Ensure the
into place correctly.
a clips
2 Pour the water into the
b compartment
compartment
c central divider
top of the central divider
d bypass
cup measure. Adjust your fill rate to
match your required cup measure.
to use your kettle
G If the
to measure more than 1 or 2 cups,
1 Fill the kettle through either the
pour the water directly into the
spout or lid. To open the lid, press
bypass opening
the lid release button. The water
level must be between 'MAX' and
care and cleaning
1 cup (250mls).
Be economical: do not boil more
G
Before cleaning, unplug your kettle
G
water than you need.
and let it cool down.
To improve the quality of your
G
drinks always use fresh water.
G Empty the kettle after each use.
.
is clipped
until level with the
for a 1
is fitted and you wish
.