Connecting Other Devices - Intel Express 510T User Manual

Installing a module
Removing the module

Connecting Other Devices

Introduction
Use shielded cables
10
1
To install a module:
If the switch is already operational, disconnect it from the main
1
power supply.
Follow the instructions in "Avoiding damage to the circuit
2
board" above.
Unscrew the screws of the plate covering the slot on the front of
3
the switch. Save these screws and plate.
4 Insert the module into the slot. Place your thumbs just beneath
the screws on the front plate of the module and push the module
in until it clicks into position. Secure it using the retaining
screws.
If the module does not click into position, refer to the
Note
Intel Support Web Page (http://support.intel.com) for
full instructions on how to install the module success-
fully.
To remove a module:
If the switch is already operational, disconnect it from the main
1
power supply.
Follow the instructions in "Avoiding damage to the circuit
2
board" above.
3 Unscrew the screws securing the module.
Pull the module gently to disengage the connectors fully from
4
the socket on the motherboard. Slide the module out com-
pletely.
Cover the empty module port with the plate and secure using
5
the screws.
Incorrect cabling is often the cause of network configuration prob-
lems.
Shielded cables normally comply with EMC and FCC emission lim-
its.
Express 510T Switch
Installation