Introduction Getting Started Achieving the Best Performance Safety Instructions Recycling Kramer Products Overview Defining the VS-211HA Automatic HDMI Standby Switcher Connecting the VS-211HA Connecting the REMOTE Terminal Block Connector Operating the VS-211HA Using the Manual Mode Using the Automatic Mode...
Introduction Welcome to Kramer Electronics! Since 1981, Kramer Electronics has been providing a world of unique, creative, and affordable solutions to the vast range of problems that confront video, audio, presentation, and broadcasting professionals on a daily basis. In recent years, we have redesigned and upgraded most of our...
Avoid interference from neighboring electrical appliances that may adversely influence signal quality Position your Kramer VS-211HA away from moisture, excessive sunlight and dust This equipment is to be used only inside a building. It may only be connected to other equipment that is installed inside a building.
Kramer Electronics has made arrangements with the European Advanced Recycling Network (EARN) and will cover any costs of treatment, recycling and recovery of waste Kramer Electronics branded equipment on arrival at the EARN facility. For details of Kramer’s recycling arrangements in your particular country go to our recycling pages at http://www.kramerelectronics.com/support/recycling/.
Overview The VS-211HA is a high-performance automatic standby switcher for HDMI video and unbalanced stereo audio signals. The VS-211HA can be used as a manual 2x1 switcher or as an automatic switcher. The switcher either uses a priority input or last connected input.
Defining the VS-211HA Automatic HDMI Standby Switcher This section defines the VS-211HA. Figure 1: VS-211HA Automatic HDMI Standby Switcher Feature Function OUT HDMI Connector Connects to the HDMI acceptor REMOTE IN 1 and IN 2 Terminal Connects to momentary contact closure switches Block Connector AUDIO OUT 3.5mm Mini Jack...
Always switch off the power to each device before connecting it to your VS-211HA. After connecting your VS-211HA, connect its power and then switch on the power to each device. To connect the VS-211HA, as illustrated in the example in Figure 2, do the following: 1.
Do not connect both the REMOTE IN1 and the REMOTE IN2 to PIN G simultaneously Momentarily Momentarily connect pin IN1 to connect pin IN2 to pin G to activate pin G to activate INPUT 1 INPUT 2 Figure 3: REMOTE Terminal Block Connector VS-211HA - Connecting the VS-211HA...
Section 5.3) Using the Manual Mode In manual mode the VS-211HA only switches when the remote contact closure switches are momentarily pressed. If you switch to an inactive input source, the output is blank. Note: A source is considered active only when there is an active clock signal coming from the source.
PRIORITY In Automatic/Last mode, the last connected input is sent to the output If Inputs 1 and 2 are active when the VS-211HA is powered on, Input 1 is sent to the output (as the priority input) ...
10% to 90%, RHL non-condensing 12cm x 7.2cm x 2.4cm (4.7” x 2.8” x 0.9”) W. D. H DIMENSIONS: WEIGHT: 0.3kg (0.66lbs) ACCESSORIES: Power supply RK-3T 19” rack adapter OPTIONS: Specifications are subject to change without notice at http://www.kramerelectronics.com VS-211HA - Technical Specifications...
Page 15
For the latest information on our products and a list of Kramer distributors, visit our Web site where updates to this user manual may be found. We welcome your questions, comments, and feedback. Web site: www.kramerelectronics.com E-mail: info@kramerel.com SAFETY WARNING...
Need help?
Do you have a question about the VS-211HA and is the answer not in the manual?
Questions and answers