Eagle Cuda 250 Installation And Operation Instructions Manual page 44

Align the bracket over the cable hole with the cable slots facing away
from you and fit the cable through one of the slots. Fasten the bracket
to the dash using the three screw holes.
Power/transducer cable
Cuda 250 quick release mounting bracket. Slots in the base allow
routing the cable from beneath the mount.
Attach the unit to the bracket by first connecting the power/transducer
cable. Then, hold the sonar unit vertically and slide it onto the bracket
from above. (The back of the unit should be touching the front of the
bracket as you lower it into position.) As you push down, the unit will
lock into place with a distinct click.
To adjust the viewing angle, pinch the ratchets with one hand, then tilt
the unit with your other hand. Release the ratchets and the unit locks
into the new position. To dismount the unit for storage, press the ratch-
ets and lift the unit off the bracket.
www.Busse-Yachtshop.de
Ratchet
Screw hole
36
email: info@busse-yachtshop.de
Rear
(away from viewer)
Cable slot