Kenwood KRF-V7300D Instruction Manual page 15

Connecting components equipped with HDMI terminals
The HDMI connection can transfer both the video and audio signals through a single HDMI cable. It makes possible entertainment of high-
quality video recorded on Blu-ray discs as well as high-quality audio including Dolby TrueHD, DTS-HD Master Audio and multi-channel
PCM audio. The HDMI connection also enables interlocking of the power of the TV with that of this unit and adjustment of the volume of
this unit from the TV. (See <HDMI setup> ‚.)
1
Using an HDMI cable, connect the HDMI input terminal ([DVD IN] or [VIDEO2 IN] terminal) of this unit to the
HDMI output terminal of a playback component such as a DVD player.
2
Using another HDMI cable, connect the [HDMI MONITOR OUT] terminal of this unit to the HDMI input terminal
of the TV monitor.
DVD Player
Using the HDMI function
The HDMI setup is required to use the HDMI function. First enable
the HDMI input as described in <HDMI input setup - "HDMI
Input"> ‚.
Flow of video signal
The digital video signal input from the HDMI input terminal is
output only at the HDMI monitor output terminal.
KRF-V9300D only :
The video up-conversion function can output the video signal
input from the VIDEO, S-VIDEO and COMPONENT VIDEO terminals
at the HDMI output terminal. (See <Video up-conversion
function> *.)
Flow of audio signal
The digital audio signal input from the HDMI input terminal
is output at the speakers connected to this unit. It can also be
output at the TV monitor connected to this unit according to the
HDMI setup. (See <HDMI setup> ‚.)
OPTICAL OPTICAL COAXIAL
od
CD(ASSIGNABLE) VIDEO2
DVD
500mA
DIGITAL IN
VIDEO COMPONENT VIDEO
VIDEO1 IN VIDEO2 IN
EO1 IN DVD IN VIDEO2 IN MONITOR OUT
Y CB CR Y CB
O1 OUT DVD IN
S-VIDEO MONITOR OUT
+
‒
L L
R R
GREEN GRAY BLUE TAN BROWN
CENTER SURROUND SURROUND BACK
SURROUND SPEAKERS (6 – 16 )
DVD IN
HDMI OUT
DVD IN VIDEO2 IN MONITOR OUT
HDMI
CR
VIDEO2 IN MONITOR OUT
HDMI
HDMI OUT
Video Player
• An HDMI/DVI converter cable is necessary to connect a TV
monitor with a DVI input terminal. The TV monitor also needs
to be compatible with HDCP (High-bandwidth Digital Contents
Protection). Note that the video may be unable to be monitored
depending on the combined components.
• Use an HDMI-certified category 2 cable (High Speed HDMI™
Cable) for the connection.
• When components are connected through the HDMI connection,
it takes a certain period before the video/audio are output
because they need mutual authentication.
• If the video and/or audio are not output normally, turn all of the
connected components off then on, and try again.
HDMI MONITOR IN
TV Monitor
15
English