Filling Scenarios - Canon High Capacity Stacker-G1 Operation Manual

Filling scenarios

Filling scenarios
Filling scenarios
Scenario
Filling with default
settings
Next job, next tray
Maximum tray filling
Limit the stack height
Filling level
18 Chapter 4 - Use the stacker
Description
The stack tray is filled until the
stack reaches the factory default
height of 302 mm (11.9"). Then
the stack is ejected.
Each new job is delivered to an
empty stack tray.
To optimize the productivity,
you can set the stack height to
maximum 355 mm (14.0").
Due to curl and an uneven toner
coverage of sheets, a slanting
stack can occur. This can result
in sheets falling off the stack
during the ejection because
these sheets can touch the un-
derside of the slide door.
See the section 'Set the maxi-
mum stack height'.
According to your needs, if
stacks must fit into boxes for ex-
ample, you can define a stack
height below the factory default
value.
See the section 'Set the maxi-
mum stack height'.
This setting is used to keep sets
together.
See the section 'Set the mini-
mum filling level'.
Where to define the settings?
On the printer control panel: [Sys-
tem] -> [Setup] -> [Workflow profile]
-> [Output] -> [Next output tray] ->
[After each job].
In the Settings Editor: [Preferences] -
> [Print job defaults] -> [Stacker] ->
[Maximum stack height].
In the Settings Editor: [Preferences] -
> [Print job defaults] -> [Stacker] ->
[Maximum stack height].
In the Settings Editor: [Preferences] -
> [Print job defaults] -> [Stacker] ->
[Minimum filling level].
Canon High Capacity Stacker-G1