5. CONTROLS AND INDICATORS
5.1 CONTROLS AND SWITCHES
This section defines each control of the transceiver. For detailed operating
instructions, refer to section "6. BASIC OPERATION". Refer to illustra-
tions for the location of the following controls, switches, and connections.
ANT Jack ( Top Panel )
The supplied CAT460 flexible an-
tenna is attached here.
MIC/SP Jack ( Top Panel )
The jack accepts the optional MH-
66
Submersible Speaker Mi-
crophone or CMP460 Noise-can-
celing Waterproof Speaker Micro-
phone. When this jack is used, the
internal speaker and microphone
are disabled.
1 ) D o n o t a l l o w t h e
HX400IS to become sub-
merged in water while the plas-
tic cover over the MIC/SP jack
is removed.
2) Do not remove/install the op-
tional Speaker Microphone in a
hazardous location.
POWER Switch / VOLUME Con-
trol ( VOL )
Turns the transceiver on and off
as well as adjusts the audio vol-
ume level.
Turn this knob clockwise to turn the radio on and increase the speakers
audio volume.
Turn fully counter-clockwise to turn the radio off.
Noise Canceling Microphone
The noise canceling microphone is located here.
Note: To cancel background noise when transmitting, care should be taken
not to cover this mic hole with your hand.
Page 16
NOTE
HX400IS