Table of Contents
Advertisement
A+ SERVER 4042G-6RF/TRF User's Manual
Installing Components in the 5.25" Drive Bays
Drive Bay Configuration
The 4042G-6RF/TRF has three 5.25" drive bays. Components such as an extra
floppy drive, IDE hard drives or DVD/CD-ROM drives can be installed into these
5.25" drive bays. See Figure 6-6 below for details.
Mounting Components in the Drive Bays
1. First power down the system and then remove the top/left chassis cover to
access the drive components.
2. With the cover off, remove the two or four screws that secure the drive carrier
to the chassis (one side only), then push the entire empty drive carrier out
from the back.
Adding a DVD/CD-ROM Drive
1. First remove the guide plates (one on each side) from the empty drive carrier
and screw them into both sides of the DVD/CD-ROM drive using the holes
provided.
2. Then slide the DVD/CD-ROM into the bay and secure it to the chassis with
the drive carrier screws you first removed.
3. Attach the power and data cables to the drive.
4. Replace the top/left chassis cover before restoring power to the system.
Figure 6-6. Adding a Component Without a Drive Carrier
6-8
Advertisement
Table of Contents
