Toshiba RAV-SM2244AT8-A Service Manual page 105

No. Part name
1. Detachment
Fan motor
10
1) Carry out the operation in 1. of
2) Remove the flange nut fixing the fan motor and the
3) Remove the propeller fan.
4) Remove the connector for the fan motor from the
5) Remove the fan motor lead from the fan motor lead
6) Remove the fixing screws (4 pieces) while support-
2. Attachment
1) Mount the fan motor.
2) Mount the individual components in the opposite
Ensure affixation of the fan motor lead to the motor
base using a metal band of the motor base and a
commercially available bundling band so that the fan
motor lead does not come to contact with the
propeller fan.
Procedure
ƒ
1. of above.
propeller fan.
• The flange nut is loosened by turning to the right.
(When tightening, turn it to the left)
inverter.
fixing rubber member of the through section of the
partitioning board.
ing the fan motor so that it does not fall.
procedure to that during detachment
∗ Points to note when assembling fan motor
• Tighten the flange nut with 4.9N•m (50kgf•cm).
• Adjust length of the fan motor lead at the fan
motor lead fixing rubber member so that the fan
motor lead is not slack in order to avoid contact
of the fan motor lead with the propeller fan.
Attach the motor lead fixing rubber member to
the partition board so that the projection is on
the refrigerating cycle side.
• Ensure that the heat exchanger does not come
into contact with the fan motor lead.
CAUTION
 ‚
, 1. of and
– 105 –
Remarks
Flange nut Flange nut Flange nut Turn to right Turn to right Turn to right
to loosen to loosen to loosen
Propeller fan Propeller fan Propeller fan
Fan motor Fan motor Fan motor
Fan motor lead fixing rubber (upper)
(mount so that the projection abuts with this side)
Fan motor lead fixing rubber (lower)
(mount so that the projection abuts with this side)
Motor base Motor base Motor base
Metal Metal Metal
band fixing band fixing band fixing
Bundling Bundling Bundling
band fixing band fixing band fixing
Metal Metal Metal
band fixing band fixing band fixing
Bundling Bundling Bundling
band fixing band fixing band fixing