Hardware Installation - Vivotek VC8201 User Manual

Hardware Installation

Drill a hole on ceiling or wall. The diameters for the installations with or without the
retention tube are different.
w/ the retention tube
w/o the retention tube
Use the M3 self tapping screws if installed without the retention tube. Note that this type of
installation does not apply to hard surfaces, such as a concrete wall.
1. Detach the top cover.
2. Install the retention tube.
3. Route the sensor cable through the hole, and then connect to the lens module.
1
2
50mm
45mm
3
VIVOTEK
User's Manual - 7