Vivotek VC8201 User Manual page 10

VIVOTEK
1. Connect 12V DC power and an Ethernet cable to the network. The camera can also be
powered by a PoE connection (up to 11.5W).
2. If preferred, install an SD/SDHC/SDXC card.
3. Connect DI and DO devices. The max. load on a DO pin is 50mA.
Item LED Status
1 Steady Red
Red LED off
2 Steady Red + blinking
LED on for 1 sec and off for another)
Steady Red +
3 Blinking Red
every 1 sec. (Red
LED on for 1 sec. and off for another)
4 Blinking Red
every 0.15 sec
10 - User's Manual
LAN / WAN
Green every 1 sec.
Green LED off
every 0.15 sec. + Blinking
LED on for 0.15 sec. and
every 0.15 sec. + blinking
SD
Description
Power on and system booting
Powered off
(Green Network heartbeat
Network disconnected
Green Upgrading firmware
Green
Green Restoring defaults
Reset
LEDs
DI/DO