Ywx0482: Weather Station Control Box - Obvius A89WS Installation And Operation Manual

YWX0482: weather station Control Box

Kit includes: control box, 2 u-bolts.
The weather station control box mounts on the back of the mast using the two u-bolts provided in the kit. The box should be
mounted with the connectors on the bottom.
Separate holes will need to be drilled into the side or bottom of the box by the installer, to provide an attachment point for a
weatherproof conduit or cable for power and communications. (power and communications wire and conduit are not
included with the weather station.)
With the mains off, connect the Line, Neutral and Ground wires to the screw terminals provided. Proper grounding is
required.
It is important to observe all electrical codes and safety practices when wiring the weather station.
WARNING: After wiring the system, remove all scraps of wire or foil shield from the electrical panel. This
could be dangerous if wire scraps come into contact with high voltage wires.
Page 10 Draft Copy A89WS Weather Station (gen 3)