Advertisement
MODELS TC9320/TC9320C
Description: A discreet housing system designed for outdoor
applications. Heaters and blowers are available as options.
Designed for pendant mounting, but can be wall, pole, or roof
mount with optional brackets. Unit is also available with liner
assembles with "L" added to part number.
Contents:
(1)
ceiling coupling
(1)
1/4-20 housing coupling
(1)
rubber gasket
(1)
black plastic shroud
(1)
upper white plastic housing
(1)
acrylic dome
(1)
metal pan/tilt mounting plate w/ quick
release plate
(1)
black inner liner (L model only)
(2)
liner support arms (L model only)
(1)
terminal block bracket
(1)
terminal block w/ cover and clips
(1)
housing packet
(4)
2.5" PVC spacers w/ mounting hardware for
mounting plate.
(1)
toolhead driver (for security screws on
acrylic dome)
1.
Remove contents from box. While unit is still "on the bench",
pre-assemble the upper housing, refering to Fig. 1.
rubber gasket over the 1/4-20 threaded studs on the metal
housing coupling. Next slide the black shroud onto the coupling,
followed by the white upper housing.
2.
Attach the terminal bracket to the pan/tilt mounting bracket,
according to the instructions on page 3.
3.
Open the housing packet and remove the (4) 2.5" spacers
and place them inside the housing over the threaded studs.
Remove the quick release plate from the mounting bracket and
slide the bracket into position over the threaded studs, a shown in
Fig. 1.
NOTE: If you are using optional heaters and/or blower, refer to
electrical accessories section on page 3 prior to installing mount-
ing bracket.
4.
Using split lockwashers and 1/4-20 hex nuts, secure this assem-
bly together.
5.
Connect mounting bracket to desired location. Bring all
necessary electrical connections down through the pipe, leaving
enough wire hanging out to feed into the housing as it is being
connected to the pipe.
6.
Thread upper housing assembly from steps 1 and 2 onto end
of 1.5" pipe until unit is tight and secure. Seal pipe threads and
rubber gasket with silicone.
Figure 1
PRODUCT INSTRUCTIONS
Ceiling Coupling
CEILING COUPLING
32-VL135
Housing Coupling
HOUSING COUPLING
32-VL448
RUBBER GASKET
SHROUD
WHITE UPPER
White Upper Housing
HOUSING
21-TOVL20
Slide the
2.5" SPACER
P/T Mounting Bracket
P/T MOUNTING
30-VL402
PLATE
HEX NUTS AND
Hex Nuts & Washers
WASHERS
P/T Quick Release Plate
30-VL407
METAL LINER
ARMS
Metal Liner Arms
30-VL384
BLACK INNER
Black Inner Liner
LINER
20-LNSS20
BLACK NYLON
PUSH SCREWS
X-mas Tree Fasteners
94-FSXM01
ACRYLIC
DOME
95-FSTD01 - Toolhead Driver
- 3 -
Advertisement
