Advertisement
PAN/TILT AND LINER ASSEMBLIES
TC6410PT
a. Mount the metal arms to the metal adapter brackets (30-
VL383 using the #6-32 x 1/2" bolts, lockwashers, and hex nuts.
Refer to fig. 2 & 3 for proper orientation and placement.
NOTE: For proper operation of pan/tilt, it is important that bolt
head is oriented against the metal adapter bracket, not the
metal arm.
Mount the two metal adapter brackets to the TC6410PT. This is
done by removing the (4) #8-32 X 3/8" bolts from the bottom of
the main pan/tilt body, as shown in Fig. 3. Place the two black
metal adapter brackets in position, and reinstall the (4) bolts.
TC6280/TC6270PT
b. When using the TC6280PT/TC6270PT, place the PUB bracket
over the drive motor, (see Fig. 4). Be certain that the bracket is
oriented so that the thin side of the PUB is offset in the same
direction as the cylindrical base of the pan/tilt. Attach metal
arms to PUB according to figures 2 and 4.
7. Connect the drive motor to the break away plate. Make sure
that the pan/tilt is attached to the quick release plate on the
same side as the slide latch fateners. Position the fasteners on the
quick release plate over the bushings on the mounting bracket
already secured to the housing. Engage the slide latch fasteners,
and secure with the (2) #8-32 bolts.
8. Connect camera and lens to the drive motor and complete
all video and electrical connections. Refer to Fig. 8. Place the
black terminal block cover over the white clips on the terminal
block, and press into place.
9. If you are using a liner, attach it to the metal arms using the (4)
black nylon push screws.
10. Fasten the wire cable located on the dome flange to the
hook riveted to the inside lip of the upper housing.
11. Attach the acrylic dome to the housing by aligning the (5)
security head screws in the dome to the receptacles in the upper
housing and securing with the toolhead driver.
12. Check all clearances and connections within the housing
and make any necessary adjustments.
complete, clean domes with mild soap and water.
When installation is
- 4 -
TC6410PT
Figure 2
#8 BOLTS
ADAPTER BRACKETS (2)
ADAPTER
BRACKET
30-VL383
30-VL383
Figure 3
Figure 4
TC6270PT
TC6280PT
TC6410PT
LINER SUPPORT
ARM
Advertisement
