Set Operating Mode 'Manned'/'Unmanned - Siemens FC10 Operating Instructions Manual

5.3

Set operating mode 'Manned'/'Unmanned'

Siemens Building Technologies
Fire & Security Products
General
You can recognize the set operating mode on the LED 'Manned'.
LED 'Manned' Operating mode
On 'Manned'
Off 'Unmanned'
When instructed persons are in the building, the operating mode 'Manned' should
be set.
For this reason the first instructed person entering the building should set the fire
detection control unit to operating mode 'Manned'. The other way round, the in-
structed person who is the last to leave the building should set the fire detection
control unit to operating mode 'Unmanned'.
Procedure
To switch between the operating modes 'Manned' and 'Unmanned', proceed as fol-
lows:
1. Enable the operating level 2 (password or key).
1. Press the key 'Manned/Unmanned'.
2. Check the setting by means of the LED 'Manned'.
Note on control units with an indicator module
The automatic switchover between the operating modes 'Manned' and 'Un-
manned' depends on the set configuration.
When switching from 'Unmanned' to 'Manned', it is possible to have the next
switchover time from 'Manned' to 'Unmanned' indicated (e.g. 18:00; see table
'Configuration').
Operation
17
007995_a_en_--.doc
04.2004