Model Type Setting - Pioneer DVR-230-AV Service Manual

1

7.1.1 MODEL TYPE SETTING

[Purposes]
When the MAIN Assy and/or JCKB Assy are(is)
A
replaced, they(it) must recognize the model of
this unit.
Items to be set: The model number and destination
must be set.
• Once the setting has been made, it can never be changed. Be sure to make the setting correctly.
[Notes]
• As this setting resets the Assy(s) in question to the factory-preset status, it is recommended that you obtain
the customer's consent beforehand.
B
[Procedures]
1
After power on, the following screen is displayed on
TV monitor. Press " 3012 " by using the remote
control unit for service.
C
2 Disconnect then reconnect the AC power cord of the
unit. Be careful not to impart vibration to the unit
immediately after the AC power cord is disconnected.
3 Reset the recorder to all its factory settings.
(Make sure that the recorder is on. Press and hold 7
(STOP) key and press
front panel.)
The recorder turns off with all settings reset.
D
4
Press [ESC] then [DISP] keys by using the remote
control unit for servicing, and then confirm the Model
Name " DVR-230/WY ".
E
End
5
F
58
1
2
(STANDBY/ON) key on the
DVR-230-S
2
3
[Tool to be used]
Remote control unit for servicing
(GGF1381)
[Recorder's Model Setting]
Input the number using the remote for Service.
> - - - -
Input No. Model
[ 30** : DVR-230 ] [ 12 : WY
[ 22 : WV
[ 32 : WY/RE
DVR-230/WY
VERSION : 3.∗ ∗
SYSCON : RELEASE_31
Rev : 3.04Z.110
TUFLCON : 870.000 Flash
DRIVE : DVD-RW DVR-R09R
1.54
DKT0000100JP
DEVICE : EMMA2RL
REGION : 2
: ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
C
FLASH : 32M
3
4
** Destination
]
]
]
OK
OK
OK
OK
4