General Information; Model Type Setting - Pioneer DVR-433H-S Service Manual

1

4. GENERAL INFORMATION

4.1 MODEL TYPE SETTING

A
[Purposes]
When the MAIN Assy and/or TUJB Assy that are(is)
commonly used with another model are(is) replaced,
they(it) must recognize the model of this unit.
Items to be set: The model number, destination, and
region No. must be set.
• Once the setting has been made, it can never be changed. Be sure to make the setting correctly.
[Notes]
B
• As this setting resets the Assy(s) in question to the factory-preset status, it is recommended that you obtain
the customer's consent beforehand.
[Procedures]
1
After power on, the following screen is displayed on
TV monitor. Press four digits properly (for example
" 2401 ") by using the remote control unit for service,
according to the screen information.
C
Disconnect then reconnect the AC power cord of the
2
unit. Be careful not to impart vibration to the unit
immediately after the AC power cord is disconnected.
Reset the recorder to all its factory settings.
3
(Make sure that the recorder is on. Press and hold 7
(STOP) key and press
D
front panel.)
The recorder turns off with all settings reset.
4
Press [ESC] then [DISP] keys by using the remote
control unit for servicing, and then confirm each
Model Name (for example " DVR-433H/WY ").
E
End
5
F
18
1
2
(STANDBY/ON) key on the
DVR-433H-S
2
3
[Tool to be used]
Remote control unit for servicing
(GGF1381)
[Recorder's Model Setting]
Input the number using the remote for Service.
> - - -
Input No. Model
[ 22** : DVR-530H ] [ 01 : /WY
[ 23** : DVR-630H ] [ 02 : /WV
[ 24** : DVR-433H ] [ 03 : /WY/RE
DVR-433H/WY VERSION : 4.∗∗
SYSCON : RELEASE_166
Rev :1.10357.2.43
TUNERCON : 835.000
DRIVE : DVD-RW DVR-R09R
1.52
DLDL000946WL
HDD : WDC WD800BB-xxJKCx
DEVICE : PRISM2-ES2
REGION : 2
: ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
C
FLASH : 64M
3
4
** Destination
]
]
]
[ 04 : /WY/GR ]
[ 05 : /WY/SP ]
OK
OK
OK
OK
80
4