Troubleshooting - EGO LM2000 Operating Manual

troublesHootinG

WARNING: always protect your hands by wearing heavy gloves or wrapping the cutting edges with rags or other
materials when performing any maintenance on the mower blade. always remove the safety key and battery pack when
servicing or transporting the mower
prOBLeM
the mower fails to start
the mower cuts unevenly
mower stops while mowing
mower does not mulch properly
excessive vibration
the handle locking clamps can
not be closed in position.
caUse
 the safety key is not inserted in the slot.
 the battery pack is depleted.
 the battery pack is not attached to the mower.
 Battery or mower circuitry is too hot. (the power
indicator on the mower will illuminate in orange
for 10 seconds)
 the side rails are not extended to their maximum
length and the clamps are not locked in position.
 the handle is not set at one of the operating
positions.
 mower deck is clogged with grass and debris.
 Dull blade.
 the cutting height is not set properly.
 the blade is assembled incorrectly.
 the battery pack is depleted.
 mower is in overload condition.
 mower deck is clogged with grass and debris.
 Battery or mower circuitry is too hot. (the power
indicator on the mower will illuminate in orange
for 10 seconds.)
 the side rail is retracted a little by the pushing
force applying on the handle.
 Wet grass clippings are sticking to the underside
of the deck.
 the mower is set to cut too much grass.
 Cutting blade is loose.
 Cutting blade is unbalanced.
 Bent cutting blade.
 Bent motor shaft.
 the side rails are not fully extended.
sOLUTION
 insert the safety key; press the key while pulling
the bail switch; release the safety key.
 Charge the battery pack.
 attach the battery pack to the mower.
 allow the battery pack or mower to cool until the
temperature drops below 152°F (67°C).
 Fully extend the handle and lock the clamps.
 adjust the handle to the operating position.
 Clean the mower deck and make certain that the
blade has freedom of movement.
 Sharpen or replace blade.
 move the deck to a higher setting.
 reassemble the blade, following the section
"inStalling tHe BlaDe" in this manual.
 Charge the battery pack.
 raise cutting height or slow down the mowing.
 unclog mower deck. raise cutting height, or cut a
narrow swath.
 allow the battery pack or mower to cool until the
temperature drops below 152°F (67°C).
 unlock the clamps. Fully extend the side rails and
lock the clamps again.
 Wait until the grass dries before mowing.
 move the deck to a higher setting.
 tighten the blade bolt.
 Balance the blade following the instructions.
 replace the blade.
 Contact the service center.
 Fully extend the side rails, then lock the clamps.
56-VOlt litHium-iOn COrDleSS laWn mOWer — lm2000
29