Fcc Statement; Safety Symbols - EGO LM2000 Operating Manual

fcc statement

1. this device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
 this device may not cause harmful interference.
 this device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTICE: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. these limits are designed to provide reasonable protection against harmful interference in a
residential installation. this equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna. increase
the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. Consult the dealer or an experienced radio/tV technician for help.

safetY sYmbols

the purpose of safety symbols is to attract your attention to possible dangers. the safety symbols and the explanations
with them deserve your careful attention and understanding. the symbol warnings do not, by themselves, eliminate any
danger. the instructions and warnings they give are no substitutes for proper accident prevention measures.
WARNING: Be sure to read and understand all safety instructions in this Operator's manual, including all safety alert
symbols such as "DANGER," "WARNING," and "CAUTION" before using this tool. Failure to following all instructions
listed below may result in electric shock, fire, and/or serious personal injury.
sYmbol meaninG
SAFETY ALERT SYMBOL: indicates DANGER, WARNING, OR CAUTION. may be used in conjunction with other
symbols or pictographs.
WARNING: the operation of any power tools can result in foreign objects being thrown into your eyes, which can
result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety
glasses with side shields and a full face shield when needed. We recommend a Wide Vision Safety mask for
use over eyeglasses or standard safety glasses with side shields. always use eye protection which is marked
to comply with anSi Z87.1.
56-VOlt litHium-iOn COrDleSS laWn mOWer — lm2000
3