Direct-vent ravenna ipi / tcc elite series (38 pages)
Summary of Contents for Lennox Hearth Products Elite E260
Page 1
INSTALLATION AND OPERATION MANUAL EPA Certified Wood-Burning Fireplace Inserts Save These Instructions Elite™ E260 For Future Reference P/N 775,210M, Rev. C 02/2010 Legacy™ C260 Wood Fireplace Inserts Legacy™/Elite™ Models C/E260 A French manual is available upon request. Order P/N 775,210CF. Ce manuel d’installation est disponible en francais, simplement en faire la demande.
Installing the Insert ..............11 available from your new wood-burning fireplace insert. Post Installation Checks ............... 11 Thank you for selecting a Lennox Hearth Products wood-burning Operating Hints ................12 fireplace insert as the answer to your home heating needs.
13. Inspect your chimney at least once a month during the burn- IMPORTANT SAFETY AND WARNIING ing season to check for soot and creosote accumulations. INFORMATION Any accumulations over 1/4” thick should be removed by a professional chimney sweep. Do not attempt to burn out heavy creosote accumulations with a hot fire.
performance problems as well as be a safety hazard. A draft test should TESTING INFORMATION read greater than .0’ W.C. (inches water column) and less than .08” W.C. As per NFPA-211 standard (see paragraph below), the installer must take into account all variables within the installation and install the This manual describes the installation and operation of the Legacy™/ appliance in such a manner that satisfies the draft requirements of the Elite™...
WARNING: IF THE BRICKS ARE NOT INSTALLED EXACTLY AS BRICK INSTALLATION SHOWN THEY COULD FALL OUT OF PLACE DURING REFUELING OR BURNING OF THE INSERT CAUSING SERIOUS INJURY. Legacy™/Elite™ C/E20 Brick Installation Legacy™/Elite™ C/E20 Brick Sizes CAUTION: Wear gloves during brick installation in case of (see Figures on this page) sharp edges inside the fireplace insert.
REqUIRED CLEARANCES Maximum Mantel Depth = 9” (229mm) COMBUSTIBLE MANTEL WARNING: BE ABSOLUTELY SURE THE DISTANCE BETWEEN THE HEATER AND THE SURFACE OF ANY COMBUSTIBLE CON- Top Facing / Trim STRUCTION IS NOT LESS THAN SHOWN ON THIS PAGE. Model E(1) C20 0”...
Using the r formula: HEARTH PROTECTION Minimum r-value (per Inch) Specified min. thickness of of listed material thickness The hearth and/or floor protection must be a thermally rated non-com- alternate r-value (per inch) of listed bustible hearth/floor protector meeting or exceeding a thermal rating material of alternate material material...
Slide the assembled trim down onto the top surround panel. Note: Although not required, a full-length stainless steel liner is recom- The surround should fit snugly in the groove towards the back of the mended for optimum safety and performance. See your Lennox Hearth trim. Products dealer for details.
POSITIVE FLUE CONNECTION A full chimney liner is recommended A positive flue connection is providing a seal between the vent pipe or Fireplace liner and the existing fireplace chimney for the purpose of preventing Chimney room air passage to the chimney cavity of the fireplace. There are differ- ent approved methods to achieve this.
Lower the chimney and make attachment to the insert. Level the fireplace NOTE: LENNOX HEARTH PRODUCTS RECOMMENDS PROFES- insert by using a 3/4” socket and a long extension and adjusting the bolts SIONAL INSTALLATION BY A LICENSED AND BONDED INSTALLER.
OPERATING HINTS STARTING AND MAINTAINING A FIRE 1. Burn only dry, well-seasoned wood for maximum heat output. In some Be sure to clean the Nickel or Gold Plated door with a house- states it is illegal to burn wet wood or anything other than clean, dry hold type glass cleaner and a very soft cloth to remove any wood products.
BLOWER OPERATION Blower Operation The blower can be operated manually or automatically (blower will turn on when the insert is hot and turn off when the insert is cool). The rocker switch on the control panel allows you to select between manual operation or automatic operation as follows (see Figure 10): MANUAL OPERATION: Turn rocker switch to the manual position (up) and adjust rheostat knob to the desired speed.
OPERATING TECHNIqUES AND HINTS ACHIEVING CLEAN, LONG BURNS Recent developments in wood-burning technology have made wood- To achieve long burn times, after having thoroughly preheated the fire- burning a cleaner and more convenient way to heat your home. Overall place insert, let the insert top cool down to 25 degrees to 00 degrees efficiency in a wood-burning appliance is a combination of combustion (on Elites, locate thermometer on the face of the insert just above the efficiency and heat transfer efficiency.
DOOR HINGES: If door hinges need lubricating, use an anti-seize SEE MAINTENANCE FOR GLASS CLEANING TIPS compound (never use oil) available from your Lennox Hearth Products dealer. The operator plays an important part in keeping the glass clean and free of buildups.
TROUBLESHOOTING Problem Solution POOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember, the fireplace inserts’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4).
DO’S AND DON’T DO NOT: Install or operate this fireplace insert before reading this manual. DO NOT: Close the draft beyond the point at which the flames are completely extinguished. DO NOT: Open the fireplace insert door without fully opening the draft first. DO NOT: Burn driftwood or wood that has been in salt water.
REPLACEMENT PARTS - MODEL C20 AND E20 119 Large Flange Screw/ Black - Seven Needed Contact an Authorized Lennox Hearth Products dealer to obtain H529 Large Flange Screw/ Gold - Seven Needed any of these parts. Never use substitute materials. Use of...
The Date On Which Your Appliance Was Installed __________________________ Your Dealer's Name _________________________________________________ Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.