Extension Cords - Delta 14-650 Instruction Manual

EXTENSION CORDS

Use proper extension cords. Make sure your extension
cord is in good condition and is a 3-wire extension cord
which has a 3-prong grounding type plug and a 3-hole
receptacle which will accept the tool's plug. When using
an extension cord, be sure to use one heavy enough to
carry the current of the machine. An undersized cord will
cause a drop in line voltage resulting in loss of power
and overheating. Fig. 19 shows the correct size to use
depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gauge. The smaller the
gauge number, the heavier the cord.
ASSEMBLING CHISEL AND BIT
WARNING: WHEN ASSEMBLING THE CHISEL AND BIT,
MAKE CERTAIN THE MACHINE IS DISCONNECTED FROM
THE POWER SOURCE.
Insert bit (A) Fig. 20, into chisel (B). NOTE: The opening
(C) on the side of the chisel should always be to the right
or left, never to the front or rear. The opening allows
chips to escape during operation.
3. Loosen screw (D) Fig. 21, and push chisel (B) up
through hole in head as far as possible. Then lower chisel
(B) 1/16" to 3/16" and tighten set screw (D). IMPORTANT:
When inserting chisel (B) Fig. 22 into head, there must
be a space of 1/16" to 3/16" clearance between the
bushing (E) and shoulder (F) of chisel as shown. This
assures having proper clearance between the cutting
lips of the bit and points of the chisel after the bit is
inserted into the chuck.
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC TOOLS
Ampere Volts
Rating
0-6 120
0-6 120
0-6 120
0-6 120
6-10 120
6-10 120
6-10 120
6-10 120
10-12 120
10-12 120
10-12 120
10-12 120
12-16 120
12-16 120
12-16 120
10
Total Length of Gauge of
Cord in Feet Extension Cord
up to 25 18 AWG
25-50 16 AWG
50-100 16 AWG
100-150 14 AWG
up to 25 18 AWG
25-50 16 AWG
50-100 14 AWG
100-150 12 AWG
up to 25 16 AWG
25-50 16 AWG
50-100 14 AWG
100-150 12 AWG
up to 25 14 AWG
25-50 12 AWG
GREATER THAN 50 FEET NOT RECOMMENDED
Fig. 19
A
B
C
Fig. 20
D
B
Fig. 21
E
F
B
Fig. 22
D