Power Switch / Hard Disk Drive Led Connectors; Rewiring Motherboard Header Connections - Antec VSK-1000 User Manual

Hide thumbs Also See for VSK-1000:
Table of Contents

Advertisement

3.3
P
S
OWER
WITCH
Connected to your front panel are LED and switch leads for power and HDD
LED activity. Attach these to the corresponding connectors on your
motherboard. Consult your motherboard manual for specific pin header
locations. For LEDs, colored wires are positive ( + ). White or black wires are
negative ( – ). If the LED does not light up when the system is powered on, try
reversing the connection. For more information on connecting LEDs to your
motherboard, see your motherboard user's manual.
Note: Polarity (positive and negative) does not matter for switches.
3.4
R
M
EWIRING
OTHERBOARD
There may come a time when you need to reconfigure the pin-out of a motherboard header connector.
Examples could be for your USB header, audio input header, or some other front panel connector such as the
Power Button connector.
Before performing any work, please refer to your motherboard user's manual or your motherboard
manufacturer's website to be sure of the pin-out needed for your connector. We strongly recommend making
a notated drawing before beginning work so that you can recover if your work gets disturbed.
1.
Determine which wires you need to remove in order to rewire your
plug to match the USB pin-outs on your motherboard (refer to your
motherboard user's manual). Working on one connector at a time, use
a very small flathead screwdriver or similar tool to lift up on the black
tab located beside the gold posts (squares). This will allow you to
easily slide out the pins from the USB plug.
2.
Working carefully so as not to damage the wires, connectors, or pins,
slowly remove the pin from the connector. Repeat these steps for each
wire you need to change.
3.
Working carefully so as not to damage the wires, connectors or pins,
slowly reinsert the pin into the correct slot of the connector then snap
closed the black tab that was lifted in step 1. Repeat these steps for
each wire you need to change.
/ H
D
D
LED C
ARD
ISK
RIVE
H
C
EADER
ONNECTIONS
ONNECTORS
13

Advertisement

Table of Contents
loading

Table of Contents