Sony MV-101 Service Manual page 7

3
A
Horizontal installation
3
2
1
4
Light sensor
15º
15º
Almost 3 m (9.8 ft)
Precautions
•Choose the mounting location carefully.
•Avoid installing the player in places:
— subject to temperatures below – 30 °C (– 22
°F) or above 45 °C (113 °F)
— subject to direct sunlight.
— subject to heat;
Keep all products away from nearby hot
vehicle components that heat up over time
such as hoses, high current wires, and
braking system components. Make sure to
leave enough room for ventilation of
openings and slots to protect from over
heating.
— near heat sources such as heaters.
— exposed to rain or moisture.
— exposed to excessive dust or dirt.
— subject to excessive vibration.
— where the fuel tank might be damaged by
the tapping screws.
— where wire harnesses or pipes might be
under the place.
— where the screws or the player itself might
damage the spare tire, tools, or other
equipment in or under the trunk.
— where the player might interfere with with
the normal movements of the driver.
— under the floor carpet, as the heat
dissipation from the player might damage
the carpet.
•Be sure to use only the supplied mounting
hardware for a safe and secure installation.
•Use only the supplied screws.
•Make holes of ø 3 mm ( 1 in) only after
/
8
making sure there is nothing on the other side
of the mounting surface.
•Do not install the player on inclined places.
Install the player on a level surface.
•Install the player just horizontally or vertically.
How to install the player (3)
When installing the player, choose the mounting
location carefully.
1
Place the player where you plan to install
it.
2
Mark the 4 positions for the holes of the
screws 3 on the surface of the mounting
board (not supplied).
The supplied mounting screws 3 are 15 mm
( 19 / in) long, so make sure that the mounting
32
board is thicker than 15 mm ( 19 / in).
32
3
Drill the 4 positions to make the holes of ø
3 mm ( 1 in) in diameter.
/
32
4
Mount the player on the board (not
supplied) with the parts 1 and mounting
screws of 2 and 3 .
3
2
1
ø 3 mm
Light sensor
Wireless remote commander
Remote control sensor (4)
Before installing the remote control sensor,
make sure the maximum signal distance of
remote control. The remote control can be used
up to approximately 3 m (9.8 ft) from the light
sensor, in a conical area spreading roughly 15º
from the light sensor.
For your safet y
After installing the remote control sensor, be
sure to use the cord cramp (not supplied) to
secure up the cord onto the passenger seat side,
as it may interfere with the normal driving
operation. It is very dangerous for the cord to
get tangled with the gearshift lever during
driving.
Warning when installing in a car
without ACC (accessory)
position on the ignition key
switch
Aft er t urning off t he ignit ion, be sure t o
press and hold t he POWER but t on on t he
card remot e commandar for more t han 2
seconds. Make sure t hat t he green light of
t he POWER but t on on t he player is t urned
off.
Otherwise, the player is not turned off and this
causes battery drain.
RESET button
When the installation and connections are
completed, be sure to open the front panel, then
press the RESET button with a ball-point pen,
etc.
B
Vertical installation
ø 3 mm
2
Remote control sensor
c
MV-101
1
3
4
2
3
7