Sony MV-101 Service Manual page 6

MV-101
1
2 * Remote signal cord with stereo mini jacks: (5m) (supplied with a Sony monitor)
connects the player MV-101 and a connection box of an optional Sony monitor.
(However, this connection is not available for XVM-R75)
2
* Remote control sensor 7 with a stereo mini jack (5m) (supplied with MV-101)
Connect the remote control sensor 7
monitor other than Sony product is connected.
3 There is an R (audio right )/L (audio left)/V (video) output on MV-101, so you can connect either XVM-
*
R70 or XVM-H65.
XVM-R70
Monitor cable (supplied with XVM-R70)
to AV input
Connection box XA-115
(supplied with XVM-R70)
Connection box XA-113
(supplied with XVM-H65)
XVM-H65
to AV input
Monitor cable (supplied with XVM-H65)
Caution
• This unit is designed for negative ground 12 V
DC operation only.
• Before making connections, turn the car ignition
off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Be sure to connect the red power input lead to
the positive 12 V power terminal which is
powered when the ignition switch is in the
accessory position.
• Run all ground wires to a common ground
point.
• The use of optical instruments with this product
will increase eye hazard.
• Use of controls adjustments or performance of
procedures of other than those specified herein
may result in hazardous radiation exposure.
Not es on t he power supply cord (yellow)
• When connecting the player in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Not es on inst allat ion
• Before installation, be sure to turn the ignition
switch to the OFF position or take the key out.
Installing the player and the monitor (not
supplied) with the ignition on may cause battery
drain or a short circuit.
• Do not damage any pipes, tubes, the fuel tank or
electric wiring when installing the player and the
monitor (not supplied). This can cause a fire. If
you drill a hole in car panels, make sure that any
hidden car parts will not be damaged.
• Do not use any nuts or bolts for safety devices
such as steering linkage, fuel supply or braking
systems. This can cause a fire or an accident.
• Take care to prevent cords and wires from
getting tangled or crimped in the moving portion
of a seat rail.
Connection diagram (2)
1 to a metal surface on the car
First connect the black ground lead, then connect
the yellow and red power input leads.
2 to the +12 V power terminal which is energized
at all times
Be sure to connect the black ground lead to a metal
surface of the car first.
3
to the +12 V power terminal which is energized
when the ignition switch is in the accessory
position
Be sure to connect the black ground lead to a metal
surface of the car first.
6
to the player MV-101 when XVM-R75, XVM-H6, or an optional
to AV output
to AV output
R/L/V
OUT
6
3
*
R
* 3 REMOTE SIGNAL INPUT
OUTPUT
1
*
REMOTE SIGNAL INPUT
Remote control sensor
2
7*
Optical cable (not supplied)
OPTICAL OUTPUT
L V
OPTICAL OUTPUT POWER 12V
5
POWER 12V
red
5 m
1A
yellow
5 m
5A
black
1 m
black
1 m
3
2
1