Diagrams; Note For Printed Wiring Boards And Schematic Diagrams - Sony MV-101 Service Manual

3-1.

NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

Note on Printed Wiring Boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Through hole.
z
• : internal component.
f
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side B) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side A) the parts face are indicated.
• Waveform
– KEY Board –
1 IC101 ws (CL2)
4.7 Vp-p
250 ns
SECTION 3

DIAGRAMS

Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1 / W or less unless otherwise
4
specified.
• f : internal component.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC cord.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : CD STOP
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Signal path.
F
: AUDIO
L : VIDEO
I : DIGITAL OUT
• Circuit Boards Location
servo board
sensor board
led board
13 13
power board
sw board
key board
MV-101