Table of Contents
Advertisement
Installation
Follow the steps below to attach the unit to the camera recorder.
<Note>
Depending on the version of the software being used with the camera recorder, it may be necessary to update it, in which case you
should consult your dealer.
T
O OU
VI DE
M IC
+4 8V
LI NE
12V 1A
DC OU T
DC IN
EC U
O O UT
AU DI
C H 2
C H 1
IN
AU D IO
M I C
L E V
I N C
O M
E L
O N
O F
P
P G
M
O N
O F
<Note>
After the AJ-CA901 has been attached to the camera recorder, the camera recorder cannot be operated independently unless it has
been connected as a system to the AJ-BS901 Base Station. When using the camera recorder unit independently, always remove
the AJ-CA901 before proceeding.
4
Coin screw
1.
Make sure that the coin screw used to secure the AJ-CA901
connectors is unscrewed (The screw will be completely
disengaged from the thread.). Mounting the AJ-CA901 with
the screw in the closed position could damage the
connectors.
2.
As shown in the figure on the left, align the spacer on the
back of the camera recorder with the guide in the unit, and
push the unit in the direction of the arrow until it clicks into
place.
3.
Screw the coin screw to the closed position while pressing
down on it.
Advertisement
Table of Contents
