Wired Remote Controller - Toyotomi DCT 100HSPi Service Manual

3.2 Wired Remote Controller

3.2.1 KJR-10B
I
Name and functions of buttons on the wire controller
6. NAME AND FUNCTIONS OF BUTTONS ON WIRE
CONTROLLER
Mode selection button
1 mode selection button:
It is used to select mode, push the button one time, then the operation modes will change
In turn as follows:
Remark: no heating mode if wire controller is set as the cool only.
2 Timer on button:
Push the button to set TIMER ON, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER ON, then adjust the time of TIMER ON as 0.0
3 Timer off button:
Push the button to set TIMER OFF, each time you push the button the time moves forward by o.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER OFF, then adjust the time of TIMER OFF as 0.0
4 CLOCK button:
Normally display the clock set currently (display 12:00 for the first electrifying or resetting). When push
the button for 4 seconds, the hour part on the clock display flashes every 0.5 seconds, then push button
and to adjust hour; push the button CLOCK again, the minute part flashes every 0.5 seconds, then push
and button to adjust minute. When set clock or alter clock setting, must push the confirm button to
complete the setting
Electrical Control System
Timer on button
TIMER ON CLOCK
Timer off button
CONFIRM OK
TIMER OFF
Clock button
confirm button Ok button
replace nutton
Reset button
AUTO COOL
ECONOMICAL
SWING
MODE FAN SPEED TEMP
RESET REPLACE LOCK COOL
HEATING
DRY FAN
HEAT
ON / OFF button
Fan speed selection
Adjust button ▲
Adjust button ▼
Swing button
Economical button
COOL ONLY/COOL and
Heating selection button
Lock button
5
Controller