Firegear ADVANTAGE SERIES Installation And Operation Instructions Manual page 7

FOR EMBER BURNER INSTALLATIONS continued
7- Place the ember burner pipe, PORT HOLES DOWN or facing the
floor, into the compression fitting, on the end of the ember burner
gas feed. ( SEE FIGURE 10 & 11 )
8- Using two (2) adjustable wrenches, one to hold the compression
base, and the other turning in a clockwise direction, install the
ember burner into the ember burner gas feed.
( SEE FIGURE 10 & 11 )
FIGURE 10
FIGURE 11
FOR MATCH THROW INSTALLATIONS CONTINUE WITH THE
NEXT THREE (3) STEPS IN THE SECTION "FOR EMBER PAN
INSTALLATION".
FOR VALVE/PILOT INSTALLATIONS, GO TO THE SECTION "FOR
VALVE/PILOT INSTALLATIONS" ON PAGE 8, AND THEN RETURN
TO THE SECTION "FOR EMBER PAN INSTALLATIONS".
FOR EMBER PAN INSTALLATIONS
1- Place the burner in the upright position.
2- Insert the bottom lip of the ember burner pan under the ember
burner. ( SEE FIGURE 12 )
3- Push the ember burner pan backwards, towards the main burner,
snapping the top of the ember burner pan beneath the grate
support. ( SEE FIGURE 13 )
FOR MATCH THROW INSTALLATIONS, GO TO THE SECTION
"FOR MATCH THROW INSTALLATIONS ON PAGE 7.
FOR VALVE/PILOT INSTALLATIONS, GO TO THE SECTION "FOR
VALVE/PILOT INSTALLATIONS" ON PAGE 8.
SET UP AND ASSEMBLY continued
7
FIGURE 12
FIGURE 13
FOR MATCH THROW INSTALLATIONS
1- Place the ADVANTAGE BURNER BURNER PAN into the
fireplace. The unit should be centered from both side to side, and
front to back. The unit is shipped, ready for rear gas connection
only. ( SEE FIGURE 2 & 3 )
2- Bend a 3/8" gas line, with two ( 2 ) 3/8" brass, female flare fittings
( included on some models ), to facilitate the gas connection,
between the burner, and the gas stub.
BE CAREFUL! Gas lines are easily kinked if bent too sharply.
3- Using an adjustable wrench, and turning in a clockwise direction,
attach a 1/2" Female Flare X 3/8" Male Flare Brass Reducer
Fitting ( included on some models ), to the gas stub.
4- Using two adjustable wrenches, and turning in a clockwise
direction, attach one end of the gas line, to the brass reducer
fitting that you have just installed on the gas stub. ( One wrench
on the brass gas line fitting, and one wrench on the brass reducer
fitting )
5- Using two adjustable wrenches, and turning in a clockwise
direction, attach the other end of the gas line to the brass fitting
on the burner. ( One wrench on the gas line fitting, and one
wrench on the brass fitting on the burner )
BE CAREFUL! Make sure all gas connections are snug, but DO NOT
over tighten!
6- TEST FIRE THE APPLIANCE! GO TO THE SECTION
"OPERATION & LIGHTING INSTRUCTIONS – MATCH THROW
UNITS" ON PAGE 14.
7- CHECK FOR LEAKS! Apply soapy water to each connection and
watch for bubbles. If bubbles are seen, turn off the gas supply;
retighten the connections, and CHECK AGAIN! DO NOT use a
lighted match or other source of ignition to check for leaks.
Repeat this procedure until you are sure that there are no leaks.
8- Proceed to "FINAL SET UP" on page 13.