Installation - Firegear ADVANTAGE SERIES Installation And Operation Instructions Manual

Installation will be much easier if two ( 2 ) or more people co-operate in
locating and installing the unit.
LOCATION
This appliance, must be installed only in a solid-fuel burning fireplace,
with a working flue, and constructed of noncombustible materials.
!!! IMPORTANT !!!
Before installing this appliance, have the fireplace and chimney,
professionally cleaned, to remove any ashes, soot, creosote, or other
obstructions. Perform this cleaning annually, after installation.
!!! IMPORTANT !!!
For units with valve applications, complete pilot placement, and gas
train assembly, before you place the unit in the fireplace.
WHEN INSTALLING THE APPLIANCE, DO NOT OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION AIR.
FOR LIQUID PROPANE INSTALLATIONS, YOU MUST USE A LIQUID PROPANE CHANGE KIT.

INSTALLATION

FIGURE 2 – ADVANTAGE BURNER PAN – MATCH THROW – FRONT VIEW
FIGURE 3 – ADVANTAGE BURNER PAN – MATCH THROW – REAR VIEW
FOLLOW THE INSTRUCTIONS THAT COME WITH THE KIT.
!!! IMPORTANT !!!
Seal any fresh air vents or ash clean-out doors located on the floor or
wall of the fireplace. If this is not performed, drafting may cause pilot
outage or sooting. Use a heat-resistant sealant; DO NOT seal the
chimney flue damper.
!!! WARNING !!!
Gas supply system must be installed in accordance with the U.S.
National Fuel Gas Code.
This appliance and its individual shut off valve must be disconnected
from the gas supply piping system during any system pressure test in
excess of ½ PSI ( 3.5 KPA ).
Use a system manual shut off valve to shut off the gas supply to this
gas appliance before continuing with installation procedures.
4