Canon NP6621 Service Manual page 227

3. Removing the Blank Exposure Lamp
1) Remove the blank exposure lamp. (See "Re-
moving the Blank Exposure Assembly.")
2) Remove the four screws
connector .
1
Figure 4-405
3) Disconnect the connector
3
Figure 4-406
4) Remove the three screws
blank exposure lamp
5
Figure 4-407
COPYRIGHT © 1998 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
, and disconnect the
1
2
.
, and remove the
.
4
CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. Removing the Blank Shutter Sole-
noid
1) Remove the blank exposure assembly.
2) Remove the blank top plate, and disconnect the
connector . (See "Removing the Blank Expo-
sure Assembly.")
3) Remove the E-ring
from the blank shutter.
4) Remove the two screws
blank shutter solenoid.
1
Figure 4-408
5. Positioning the Blank Shutter Sole-
noid
Adjust the position of the solenoid so that bottom
A is 9.5 ±0.5 mm on both sides when the solenoid
is moved in the direction of ON. Do not force the
shutter excessively.
After the adjustment, check to make sure that
the solenoid moves smoothly.
Figure 4-409a
Figure 4-409b
MECHANICAL SYSTEM
, and remove the link arm
, and pull out the
3
2
4
4–35