Working With Microsoft® Activesync - Medion GoPal E4x70 Instruction Manual

22.2.2. ActiveSync®-Mode
Repeat the attempt to connect, if it has failed the first time, if you have selected the
ActiveSync® mode.
Follow the instructions on your screen. The program will now set up a partnership
between your PC and navigation system.
PLEASE NOTE!
The navigation system must have been recognized when setting up the
ActiveSync® mode, in order to be able to work with the GoPal.
22.2.3. Alternative possibility of charging the battery
The battery will charge as soon as you connect your navigation device to a
switched-on PC or notebook by means of a USB cable.
No additional software or updates is required for your PC to perform this function.
Do not interrupt the charging process if possible during the initial charge.
PLEASE NOTE!
The brightness will be adjusted downwards, if necessary, if a USB
connection is being set up when the device is switched on.
It is recommended to set the device to the stand-by mode, in order to
shorten the charging time by USB.
22.3. Working with Microsoft® ActiveSync®
ActiveSync® will be started automatically if you connect your navigation system to
the PC. The program will check whether the device is one with which a partnership
has been entered. If this is the case, the changes that have taken place on the PC
and on the navigation system since the last synchronisation will be compared
and adjusted to each other. You will be able to define exactly which data will have
priority during the synchronisation in the settings of the ActiveSync® Program. Call
up the Help of the Program (with the F1 Button), in order to become familiar with
the effects of the respective settings. A restricted Guest Access, with which you
will be able to exchange data, for example, will become active automatically if the
navigation system has not been recognised as a partner. If this is the case, although
the process concerns the registered partner device, separate your navigation
system from the PC and switch it off and on again. Now connect your navigation
system to the PC, to restart the recognition process. Repeat the process and, restart
your PC in addition, if your device continues to be recognised as a guest.
PLEASE NOTE!
Make sure that you always connect your navigation system to your
PC with the same USB connection, otherwise your PC will allocate an
additional ID and reinstall the device.
69 of 82