Electrical Motor Specifications - Pearl PA-7 Owner's/Operator's Manual

from the ruler guide. On the other hand, if the table shifts
to the left, a shim needs to be added to the guide roller
closest to the ruler guide. Remove the appropriate guide
roller to insert a shim between the roller and table, then
reattach. (see figure 9) Depending on the severity of the
shift, more than one shim may be required.
Table Bracket
Guide Roller
Shim
3. After adding shim(s), mount the table onto the guide rails
and realign the table to the blade using method 1. Check
to see if any shifting persists. A shift tolerance of 0.2mm
is allowed. A shift in excess of that will require further
adjustment—repeat step 2.
4. Once alignment is successful, restore the table bracket to
its original position and secure it in place by tightening
the affixed bolts.
x. ELETRICAL MOTOR SPECIFICATIONS
PA-7 TILE SAW
Horse Power 3/4 hp
Volts 115 V/ 60hz
Amps 7.5 amps
Motor RPM 6,350 rpm
Cycle 60
Phase 1
WIRE
LENGTH OF CORD
GAUGE
25'
No. 12
50'
No. 10
75'
No. 8
LEVELING
This procedure levels the table so that it is perpendicular to
the blade and flush against the rails.
1. Loosen the bolt on the flat roller plate so that the roller
can swing freely about the bolt. (see figure 10) Do this for
both flat roller plates.
Figure 9
Ruler Guide
2. Hold the table against the rails. The flat rollers should
reposition themselves to maintain contact with the rails.
If the table is not perpendicular to the blade, lift the right
side of the table instead to obtain the proper angle. A
square tool will be required to confirm the angle. Tighten
the bolts. Check the table for play. Repeat step 1 if some
play is still present.
Recommendations:
• It is recommended that a 7.5 amp circuit be used while operating this
saw. This will prevent possible power interruption or loss.
• Always plug saw as close as possible to the power source while
operating. This will allow you to receive optimum electricity.
WARNING: To avoid permanent motor damage you must use
the correct extension cord. Never use more than one extension
cord at a time. Follow the chart for proper size.
Electrical Wiring Diagram
– 14 –
DJUSTMENT
Figure 10
Bolt
Flat Roller
Bolt
Flat Roller