Filling Boiler - McCulloch MC1385 Owner's Manual

FILLING BOILER

1. Place Deluxe Canister Steam System on a flat, level surface.
2. Make sure illuminated On/Off Switch is turned to "Off" and grounded power cord is unplugged
from electrical outlet.
If unit has been in use, always use the following safety precautions before
!
removing the Boiler cap to add water:
• Allow unit to cool for 20 minutes or until pressure gauge is at zero.
• Press and hold Steam Trigger to release ALL remaining steam.
WARNING: Failure to follow these precautions may result in burns from escaping steam
when the Boiler Cap is removed.
3. Cautiously unscrew and remove Boiler Cap.
4. Drain any water remaining inside Boiler.
NOTE: The Boiler should be emptied after each use – this will help minimize mineral
build-up and prevent over-filling.
5. Using the Fill Cup, fill the unit with 64 oz (1,892 ml) of water.
NOTE: In order to significantly reduce mineral build-up and prolong the life of your De-
luxe Canister Steam System, use of distilled or de-mineralized water in the unit is highly
recommended. Refer to Page 16 for more information about mineral build-up.
WARNING: Caution should always be used when pouring water into the Boiler. Do not
look directly down into fill hole when filling. Keep your free hand and any children or
pets at a safe distance.
6. Replace Boiler Cap, ensuring that it is screwed on tightly to prevent hot steam from escaping
and causing injury.
Using Your Deluxe Canister Steam
System
ENGLISH | 13