Step 5: Configure The Ip Groups; Figure 5-14: Ip Group - For Paetec Server - AudioCodes Mediant 800 Configuration Manual

Configuration Note
5.5

Step 5: Configure the IP Groups

This step describes how to create IP groups. Each IP group represents a SIP entity in
the device's network. Create IP groups for:
1. PAETEC SIP Trunk
2. Lync Server 2010 – Mediation Server
These IP groups are later used by the IP2IP application for routing calls.
To configure IP Groups:
1. Open the 'IP Group Table' page (Configuration tab > VoIP menu > Control
Network> IP Group Table).
2. Define an IP Group for the PAETEC SIP Trunk as follows:
a.
b.
c.
d.
e.
Version 1.0 Issue 1.0
Figure 5-14: IP Group – for PAETEC Server
2a
2c
2e
IP Group Index '1'
Type: "SERVER"
Description: arbitrary name. (e.g., "PAETEC")
Proxy Set ID: "1" (represents the IP address, configured in Section
page 45, for communicating with this IP Group).
SIP Group Name: The SIP Request-URI host name used in INVITE
messages sent to the IP Group, or the host name in the From header of
INVITE messages received from the IP Group. Enter the WAN IP address.
5. Configuring the E-SBC Device
47
2b
2d
5.4 on
October 2011